In a lot of procedures the fatal risk warnings are grouped in a section at the front, which means the operator reads them once at the start and is twenty steps away from them by the time the actual exposure happens. The layout usually comes from document templates and writing habits, where warnings are collected together so they are easy to review and approve, rather than from thinking about when the operator actually needs them.
A warning only helps if it shows up right before the step where the hazard exists, because by the time an operator reaches the step where a line is opened or an energy source is released, they are focused on the task in front of them. A warning read twenty minutes earlier at the front of the document is much less likely to shape what they do in that moment than one that appears just before they act.
The fix is to attach each warning to the specific step or steps where the exposure happens, so it appears on screen right when the operator reaches that point in the job. If the same hazard applies at several points, such as stored energy during both isolation and reinstatement, the warning should appear at each of them, and the wording should be specific to that step, stating what the hazard is and what the operator must have done or confirmed before going on.
When procedures are digital and broken into individual steps, this is straightforward, and it turns the warning from something read once into something seen at the right moment. Placing the warning on the step also makes it easier to pair with an action, such as confirming that an isolation has been verified or that a gas test is current, so the warning is followed by something the operator records rather than just something they read.
Moving warnings out of a front section is a good time to review them, since many procedures carry generic warnings that do not relate to any step at all, along with warnings repeated so often that they have stopped meaning anything. The review should involve the safety team and experienced operators together, so each remaining warning is tied to a real exposure in the job and written in language that will be understood at the equipment.
